Author Topic: Inspire Clone Modifications...  (Read 288 times)

Offline DVA

  • Drinks Maker
  • *
  • Posts: 5
  • Karma: +0/-0
  • rookie
    • View Profile
Inspire Clone Modifications...
« on: June 02, 2019, 12:38:58 PM »
Hello everyone ... I am a beginner and in full contruction of an Inspire V1 clone ... after having modified to pass in 6S the frame as well as the supports engines, the gimbal from the excellent files of CdRsKull (.stl reworked ) I can not operate the MG 995 Tower Pro engine (modified in 360 į via You Tube tutorials). I have in fact a permanent request of the IDE of update of the libraries ... and I can not find again the file PinChangeInt Master ... a priori the libraries are "obsolete" ...
My cabling is as follows ... X8R (Sbus) to RMILEC converter for Pwm signal, then Pin D2 (signal input) ... all the rest of the wiring is as indicated by CdRsKull ...
Thank you for your help that I can advance and share everything by videos ... Good flights

Offline Rc-Archer

  • Drinks Maker
  • *
  • Posts: 4
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Inspire Clone Modifications...
« Reply #1 on: June 02, 2019, 04:15:07 PM »
I didnít want to deal with modifying a MG995 servo, Arduino or the micro switches so Iím just using a 6 turn sail winch servo. ( For RC sailboats)  It is basically plug in and then set end-points on the transmitter.  You might be able to use a 4 turn sail winch servo but check your setup first.

Offline DVA

  • Drinks Maker
  • *
  • Posts: 5
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Inspire Clone Modifications...
« Reply #2 on: June 02, 2019, 05:24:04 PM »
Thank you Rc-Archer for the quick answer but some pictures of the editing would be welcome ... I started and a sailboat winch speaks to me even less than the arduino ... :D