Author Topic: Inspire Clone Parts required  (Read 43351 times)

Offline Bioethical

  • Global Moderator
  • Designer
  • *****
  • Posts: 237
  • Karma: +2/-0
  • "Patience is the mother of science"
    • View Profile
Re: Inspire Clone Parts required
« Reply #60 on: July 18, 2018, 05:53:41 AM »
I'm sorry. Yes, is middle to side.  In other words, is 16" from front propeller to front propeller. Same thing about rear propellers. This measure was taken when the drone is resting on its legs. Positioned a little higher than middle horizontal arms position.

Offline paytufo

  • Drinks Maker
  • *
  • Posts: 3
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Inspire Clone Parts required
« Reply #61 on: July 18, 2018, 06:46:51 AM »
Thank you very much

Offline Mikrodrohne

  • Drinks Maker
  • *
  • Posts: 1
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Inspire Clone Parts required
« Reply #62 on: January 25, 2019, 09:42:32 AM »
Good morning, can anybody help me out: I have print all of them and start to assembling.Now I can not find the file for the part I marked in that picture.
My motors are E600 with the 30A/6S ESC from DJI. The Fc will be Naza MV2.
For the LED I will use the flasher from Flytron in white.
Thanks for help in advance
Helmut


Offline Bioethical

  • Global Moderator
  • Designer
  • *****
  • Posts: 237
  • Karma: +2/-0
  • "Patience is the mother of science"
    • View Profile
Re: Inspire Clone Parts required
« Reply #63 on: January 29, 2019, 01:26:11 AM »
Hello friend,
Congratulations for the advancement on your build. In order to find that part, you to check in the STL pack 1.4, two parts (one for each side of the drone). There are two options: INNER UNDER ARM LINK FOR BEARING hK0306  AND INNER UNDER ARM FOR BRASS HAT. You need two print one part for each side of the drone either the option for bearing or the option for brass.
Sorry for the delay in answering you,

Victor
« Last Edit: January 29, 2019, 02:07:42 AM by Bioethical »