« previous next »
Pages: [1]   Go Down

Author Topic: optimized upper parts for more space  (Read 1847 times)

Offline mabo

  • Drinks Maker
  • *
  • Posts: 4
  • Karma: +0/-0
  • rookie
    • View Profile
optimized upper parts for more space
« on: February 07, 2018, 07:56:07 AM »
Hello due to a space problem I have optimized the tops a little bit.

The catch is a little tight but after a little finishing with sandpaper and file it fits quite well.



« Last Edit: February 07, 2018, 07:58:47 AM by mabo »
Logged

Offline Gunone69

  • Drinks Maker
  • *
  • Posts: 1
  • Karma: +0/-0
  • rookie
    • View Profile
Re: optimized upper parts for more space
« Reply #1 on: December 06, 2018, 12:43:21 PM »
I know this is old but we are new at drones and 3d printing. My son and I have gotten into this hobby full bore and love this Mavic Clone build. Our setup is a Naza M V2 and these mods are great for us but we were wondering if anyone has made a new rear latch to go with this taller setup. I am planning on stretching the old design if no one has done this already.

Thanx

Gunone69 and son
Logged

Offline Kananga

  • Designer
  • ***
  • Posts: 116
  • Karma: +5/-0
    • View Profile
Re: optimized upper parts for more space
« Reply #2 on: December 13, 2018, 05:50:22 AM »
My printer didn't do the latch very well on the f3 version, it looks fine but it just doesn't fit, I thought the printer could have shrunk it or somthing, the inner curve stops it engaging the lump in the lid and when I shaved it back the cut out didn't fit the lump.
Now youve said it I'm wondering if the two latch files are the same or not, I can't just check right now but will later.
I was going to redraw the latch but if it's different to the naza version it may not be of much use to you.
Logged
Pages: [1]   Go Up
« previous next »