Author Topic: Carbon Fiber PLA Build Diary  (Read 5386 times)

Offline killsec

  • Drinks Maker
  • *
  • Posts: 12
  • Karma: +0/-0
  • ZOMGH4XZ
    • View Profile
Re: Carbon Fiber PLA Build Diary
« Reply #15 on: February 16, 2019, 02:33:09 PM »
Okay so I think I figured out the endstops but now all that remains is wiring up the motors and the servo. I have a frsky x8r and a naza m lite. If i use the x8r and naza in sbus, do I plug the 4 motor signal wires in to the naza, and the servo in to port 1 on the x8r? And if I add a camera gimbal does that also get plugged in to the x8r?
« Last Edit: February 16, 2019, 04:23:18 PM by killsec »

Offline ms2k

  • Drinks Maker
  • *
  • Posts: 9
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Carbon Fiber PLA Build Diary
« Reply #16 on: July 04, 2019, 03:34:28 PM »
Sorry for the late response i had put this project myself on hold to after I had servo's break on me.

But yes you go from the SBUS port to on you x8r to the NAZA fc X2 i believe and depending on your gimbal you wanna use you can control it from the naza or on port 8 of your reciever. (I you want to use naza for the gimbal control you need to upgrade(hack your v1 to v2 if you have a v1) and then you can use the F2 port on the naza to control the pitch and the F1 if you have no gimbal board to control the roll.

if you have a gimbal control board never use the positive voltage cable back to your fc just use the negative and the signal wire and only use the pitch (F2)

hope you had all working though before i typed here

Greetings