Author Topic: My Inspire clone build (in blue ABS) Finished  (Read 18407 times)

Offline imbashammy

  • Drinks Maker
  • *
  • Posts: 21
  • Karma: +0/-0
  • rookie
    • View Profile
Re: My Inspire clone build (in blue ABS) Finished
« Reply #45 on: August 19, 2015, 12:02:42 PM »
Hi Steve,
Thanks. I've sent you an email with the files.
Cheers, Folkert

Offline Eltrocha

  • Junior Designer
  • **
  • Posts: 58
  • Karma: +1/-0
  • rookie
    • View Profile
Re: My Inspire clone build (in blue ABS) Finished
« Reply #46 on: September 30, 2015, 01:20:14 AM »
imbasammy, when you say you skipped the arduino completely, you mean you just did not use it and therefore did not use the microswithces and hooked up the servo directly to the receiver bearing in mind about the 7.2 DC volt converter?

Offline Busted44

  • Elite DIY RC Supporter
  • Junior Designer
  • ******
  • Posts: 64
  • Karma: +0/-0
  • rookie
    • View Profile
Re: My Inspire clone build (in blue ABS) Finished
« Reply #47 on: May 01, 2016, 06:57:14 AM »
Hi Imbashammy,


Excellent build.  I was just wondering how you are getting on with the quad 10 months later, ie are you still flying it or anymore modifications made?


I started to print out my parts Friday and almost finished, just working through the order list of additional hardware required.


Excellent work done by Cdrskull, I had started on the other dji inspired clone on thingiverse but gave up on it in favour of this, good choice me thinks.


Cheers
Buster.