Author Topic: Mavic Build APM 2.8 - Bioethical  (Read 3511 times)

Offline Bioethical

  • Global Moderator
  • Designer
  • *****
  • Posts: 237
  • Karma: +2/-0
  • "Patience is the mother of science"
    • View Profile
Mavic Build APM 2.8 - Bioethical
« on: February 19, 2017, 11:34:02 PM »
Please do not print the Base of the Mavic as it comes the STL facing down ( the tummy of the drone pointing upside). I did it and that was the most ridicule mistake ever in the history of 3D printing and drone building.
Now, I have finished printing all the parts but the base took more time than all others parts together.
« Last Edit: May 29, 2017, 06:17:19 PM by Bioethical »

Offline CdRsKuLL

  • Administrator
  • Master Builder
  • *****
  • Posts: 835
  • Karma: +58/-3
  • The fat dude
    • View Profile
Re: Mavic Build - Bioethical
« Reply #1 on: February 20, 2017, 08:29:49 AM »
Please do not print the Base of the Mavic as it comes the STL facing down ( the tummy of the drone pointing upside). I did it and that was the most ridicule mistake ever in the history of 3D printing and drone building.
Now, I have finished printing all the parts but the base took more time than all others parts together.

Hi Bioethical,

Someone mentioned this in a post so I have corrected all the orientations of the STL's. Anyone that has downloaded in the last couple of days will be fine :-) BUT if you were quick off the mark then My Bad.. completely forgot to change a few pieces over which has caused your problem. 

Really sorry fella.. they are all corrected now so if you either re-download or just rotate the parts you have.

Steve
« Last Edit: February 20, 2017, 08:32:20 AM by CdRsKuLL »
If you use any of my designs and can afford to donate to help pay for this site and the filament, or just buy me a beer then please click on the link below, enter an amount and donate what you want.


Offline Bioethical

  • Global Moderator
  • Designer
  • *****
  • Posts: 237
  • Karma: +2/-0
  • "Patience is the mother of science"
    • View Profile
Mavic Build APM 2.8 - Bioethical
« Reply #2 on: May 29, 2017, 02:07:53 AM »
This build is finished. It is arming and spinning, but I think PID settings may need to be adjusted in order to the back propellers to get leveled with the front propellers while flying. Am I right?
That is to compensate the difference of position between higher front and lower back propellers  I'm using flight controller APM 2.8 with mission planner. Any suggestion will be appreciated.
« Last Edit: May 29, 2017, 06:31:20 PM by Bioethical »