Author Topic: Just about finished....  (Read 1085 times)

Offline Millerboy3

  • Drinks Maker
  • *
  • Posts: 6
  • Karma: +0/-0
  • rookie
    • View Profile
Just about finished....
« on: April 06, 2018, 09:01:57 PM »
Did the mavic Naza build with latest 4.1 files.  Seemed to come out great!    It was tough to squeeze all the wiring in there with separate ESC's but I used littlebees so it is ok.

-Naza lite (with v2 firmware)
-6channel flysky
-Multistar Elite 2204-2300kv
-5in props
-printed in PLA/ABS

Very stable, wondering if I could get a slightly bigger battery and more room under the rear cover?
Just need to replace the RX in it with one thats smaller and easier to place. Also working on a 3d printed gimbal on the front. 







« Last Edit: April 06, 2018, 09:24:24 PM by Millerboy3 »

Offline iRazoR

  • Elite DIY RC Supporter
  • Builder
  • ******
  • Posts: 255
  • Karma: +5/-0
  • rookie
    • View Profile
Re: Just about finished....
« Reply #1 on: April 09, 2018, 08:40:38 AM »
Im wondering if it will fly with 5in Props?!
- David

Offline Millerboy3

  • Drinks Maker
  • *
  • Posts: 6
  • Karma: +0/-0
  • rookie
    • View Profile
Re: Just about finished....
« Reply #2 on: April 09, 2018, 11:33:53 AM »
I printed everything but the legs at 15%-20% infill with PLA. It flies. But requires the 6in props to hover with lower throttle than 60%.  However I've already ordered some 2212 920kv motors and some 9in/10in props to use instead so I replace these. this was mostly an experiment to see if it would work until my bigger motors arrived.  I'm in the middle of printing a 3axis gimbal for it so I need the extra power.  Good point though!
« Last Edit: April 09, 2018, 11:35:57 AM by Millerboy3 »

Offline STiXzoOR

  • Junior Designer
  • **
  • Posts: 68
  • Karma: +1/-1
  • rookie
    • View Profile
Re: Just about finished....
« Reply #3 on: April 09, 2018, 02:32:38 PM »
can you share your 3 axis gimbal design files? thanks