DIY RC

Do It Yourself RC => 3d Printed Mavic Clone => Mavic Build Diaries => Topic started by: Luke norman on July 09, 2018, 05:01:30 AM

Title: Naza v2 build
Post by: Luke norman on July 09, 2018, 05:01:30 AM
Just got my build almost completed. Will get it finished in the next few days.

Phantom 1 Naza upgraded to v2
Sunny sky 2204 2300kv(upgrading to either 2208 1400kv or 2212 980kv).
6" cg035 props for now
Printed in pla

I can just squeeze a 2200 3s in, but I feel I could go bigger if I could fit the pmu elsewhere, any that has the v2 pmu, where are you putting it too?

I just reposted this as I realized it wasn't under the build diaries
Title: Re: Naza v2 build
Post by: archangr on July 12, 2018, 03:58:56 AM
Hi, very nice job. Congrats!
Title: Re: Naza v2 build
Post by: josemi on September 01, 2018, 12:34:16 AM
Hello Luke. Great job. I have seen that you have naza v2 in the mavic clone. The, the esc where you put them, on the legs or inside the room? Thank you. A greeting.
Title: Re: Naza v2 build
Post by: Mkc2 on September 02, 2018, 12:34:47 AM
Looking good  ;)
Title: Re: Naza v2 build
Post by: stevedjarrell on September 24, 2018, 01:18:48 AM
 That looks great, One question for you, I am building my first Naza Mavic 4.1.  What does everyone doe for a PDB?  Do you use a small one or do you just build a power "web"?  since the PMU is running most everything?  I was looking for a small PDB with a built in BEC for the camera / extras but wanted to ask.  I have read a bunch of these and see very little on it other than the PDB in the BOM.  Thank you,

-Steve