Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - antonello_69

Pages: [1] 2
1
Mavic Build Diaries / Re: Mavic di Antonello
« on: January 07, 2019, 02:49:38 PM »
ok grazie  ;)

2
Mavic Build Diaries / Re: Mavic di Antonello
« on: January 07, 2019, 02:13:36 PM »


I saw this that looked good I just redesigned the piece that connects the gimbal to mavic do you think it's wrong?https://www.youtube.com/watch?v=FkElyRgdvtI

3
Mavic Build Diaries / Re: Mavic di Antonello
« on: January 07, 2019, 11:37:36 AM »
I would like to disassemble it and put the objective externally and inside the card

4
Mavic Build Diaries / Re: Mavic di Antonello
« on: January 07, 2019, 11:35:25 AM »
this is for a runcam 2 hd what do you think is not good?

5
Mavic Build Diaries / Re: Mavic di Antonello
« on: January 07, 2019, 10:49:28 AM »
I made an attack for our mavic for gimbal this is the result, I mounted the gimbal with two screws but I'm waiting for the rubber cushions

6
hello nice choices even the beautiful camera I wanted to ask, however, the gimbal is attached to the frame only by the rubber pads?

7
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 29, 2018, 05:23:45 PM »
ok thanks you are really very kind to respond so fast thanks again ;)

8
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 29, 2018, 04:56:48 PM »
ok for now thanks I think I have to put together all the parts needed to fly the mavic then I start thinking about the camera but I think a runcam split 2 is very beautiful even the runcam 3 should not be bad what do you say?

9
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 29, 2018, 03:36:22 PM »
thank you so much for your reply Kananga  I think I'll do the order if then I would like to install a gimbal what do I do? and I can mount it directly on this flight control thanks

10
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 27, 2018, 04:19:29 PM »
here I am after so much research time I managed to make the list of electronic components I hope you can answer me to say if all the pieces are compatible thanks.











11
3d Printed Mavic Clone / Merry Christmas and happy holidays!
« on: December 24, 2018, 10:23:19 AM »
Merry Christmas and happy holidays!



12
3d Printed Mavic Clone / Re: Mavic di Antonello
« on: December 22, 2018, 08:48:47 AM »
Hello everyone I'm starting to make a list of the electronic parts and I wanted your advice since I'm a beginner what do you think of the spracing f7 dual? http://seriouslypro.com/spracingf7dual

13
Hi foldingllama good luck  ;)

14
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 20, 2018, 04:33:40 PM »
Other photos

15
Mavic Build Diaries / Re: Mavic di Antonello
« on: December 20, 2018, 04:31:07 PM »
Other photos

Pages: [1] 2