Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DVA

Pages: [1]
1
3d Printed Inspire Clone / Re: Inspire Clone Electronics
« on: June 05, 2019, 04:08:11 PM »
Bonsoir à tous...je suis en pleine contructions de l'Inspire auquel j'ai modifié la canopy pour un cadre en Lipo 6S, + un support pour gimbal + des pieds amortissables + supports moteurs pour des 5008 340kv...par contre malgré le schéma pour l'arduino ( CdSrKull ) j 'ai une demande de mise à jour de bibliotheques permanente par l'IDE a chaque fois que je met en route l'arduino et je ne retrouve plus le fichier PinChangeInt-Master...
Merci pour votre aide que je puisse avancer et terminer mon projet et creer les videos de partage....
Bons vols à tous.Philippe

2
3d Printed Inspire Clone / Re: New Airframe and Canopy Design
« on: June 05, 2019, 03:58:22 PM »
Ainsi que sur un nouveau support de gimbal et un cadre pour lipo 6S...

3
3d Printed Inspire Clone / Re: New Airframe and Canopy Design
« on: June 05, 2019, 03:32:11 PM »
Excellente idee que de modifier la canopy...j'y ai travaillé aussi ainsi qu'une autre gimbal et ouverture pour une 6S...

4
3d Printed Inspire Clone / Re: Inspire Clone Modifications...
« on: June 02, 2019, 05:24:04 PM »
Thank you Rc-Archer for the quick answer but some pictures of the editing would be welcome ... I started and a sailboat winch speaks to me even less than the arduino ... :D

5
3d Printed Inspire Clone / Inspire Clone Modifications...
« on: June 02, 2019, 12:38:58 PM »
Hello everyone ... I am a beginner and in full contruction of an Inspire V1 clone ... after having modified to pass in 6S the frame as well as the supports engines, the gimbal from the excellent files of CdRsKull (.stl reworked ) I can not operate the MG 995 Tower Pro engine (modified in 360 ° via You Tube tutorials). I have in fact a permanent request of the IDE of update of the libraries ... and I can not find again the file PinChangeInt Master ... a priori the libraries are "obsolete" ...
My cabling is as follows ... X8R (Sbus) to RMILEC converter for Pwm signal, then Pin D2 (signal input) ... all the rest of the wiring is as indicated by CdRsKull ...
Thank you for your help that I can advance and share everything by videos ... Good flights

Pages: [1]